CERN Accelerating science

Configuration

Examples of RFC4890-compliant ICMP filter configuration.

We include here two reference translations of the ICMP filtering rules recommended in RFC4890 into access lists for Cisco and Juniper edge routers in the case that Mobile IPv6 is not used.

How to add an IPv6 xrootd-based file server to the testbed via Docker.

The following installation has to be done on a host where docker.io is installed and running. It was tested with versions 1.6.2 on Debian stable and 1.9.0 on Centos 7:

FTS3.0 server for IPv6 compatibility testing

general FTS3 setup instruction https://svnweb.cern.ch/trac/fts3/wiki/AdminGuide (tested OS Scientific Linux release 6.2 (Carbon))

 

Followed Duncan's guidelines (knowledge base)

How to configure dCache 2.6 with IPv6

This page summarizes the steps taken to configure dCache server for IPv6 compatibility testing.

1. Install dCache and configure it following the documentation page in dCache.org

http://www.dcache.org/manuals/Book-2.6/index-fhs.shtml

2. Before start dCache service you need to do some changes in postgreSQL and dcache.defaults configuration

How to create a standalone FTS server for IPv6 compatibility testing

This page summarizes the steps taken to create a standalone FTS server for IPv6 conpatibility testing. The steps are rather complex. They are not recommended for installation on other testbed nodes.

How to configure a standalone gridftp server to access the IPv6 Testbed

Follow these steps to add to SLC5 a standalone gridftp (both server and client) installation allowing access to the IPV6 testbed VO:

Subscribe to RSS - Configuration